Cadence QRS SERIES Installation Guide download pdf (Page 14)

Channels 1 and 2 should be wired to speakers no lower than 2 ohm loads per channel in stereo. Channel 3 and 4 should be bridged as

per the diagram wiring the woofer to Channel 3 positive side (+) and Channel 4 negative side ( – ) terminals.

Set the crossover mode switch of Channels 1 and 2 to either Full Range or High Pass, while Channels 3 and 4 should be set to Low

Pass. Please see page 11 for RCA input conguration details and instructions when wiring a 3 channel system.

4 Channel Amplier in 3 Channel Mode (Q3000, Q4000)

LEFT SPEAKER

2-4 OHM

RIGHT SPEAKER

2-4 OHM

SUBWOOFER

MINIMUM IMPEDANCE

4 OHMS

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

No comments

Cadence QRS SERIES Installation Guide Page 14