FEATURES
3
3
POWER AND PROTECTION CIRCUITRY:
QRS Series ampliers feature our unique IC controlled protection circuitry. This sophisticated circuit constantly monitors the heat sink internal temperature and various
voltages, adjusting the amp automatically and protecting it from dangerous conditions. The 2 LED’s located on the side of the amplier provide indication of the amplier
status, the Power LED will light when the amplier is receiving proper power, ground and remote voltages and the IC monitoring sequence indicates the amp is functional. In
case the amplier encounters a diagnostic condition as listed below, the second LED will light indicating a Diagnostic condition. When a diagnostic condition is sensed the
amplier will then turn into a self preservation mode and if the cause of the diagnostic condition is not corrected will eventually shut down. There are certain critical diagnostic
conditions which will turn the amplier off immediately.
1. Speaker short circuit.
2. Input Overload.
3. Thermal overload.
4. Reverse Polarity.
To reset the amplier, you must rst diagnose what caused the problem, correct the fault and restart the system.
MUTE CIRCUIT:
The QRS Series ampliers feature an anti-thump, mute and delay circuit. This eliminates irritating speaker damaging turn-on and turn-off transients normally experienced with
less expensive ampliers.
BASS EQUALIZATION CIRCUITRY:
A narrow “Q” shelving equalization circuit is included in the ampliers. The equalization system is preset at 45Hz. The boost control allows you to add up to +12dB of Bass EQ
effect. Utilize the Bass EQ to tailor your bass response to your systems needs. Please keep in mind that by adding Bass EQ you are adding stress on your speakers. Make sure
your speakers can handle the extra power output! It would be foolish to add 18dB of gain to low excursion 8” and 10” Sub woofers or mid ranges and tweeters. It’s a sure way
to blow your speakers. The Bass EQ was designed for High Power sub woofers.
“ADR”: - ACTIVE DYNAMIC REGULATION
Cadence QRS Series ampliers feature our proprietary ADR, Active Dynamic Regulated power supplies. 100% HexFET devices are utilized in the power supply for high speed
(100KHz) switching frequencies. The power supplies are capable of supplying the main amplier with a considerable amount of reserve voltage for peak “high demand”
situations. The ADR circuit provides full bandwidth power for authoritative bass response, high current output into low impedance loads and increased headroom. The ADR
is supplied with power via a high speed, high temperature capacitance bank and 100% pure copper rails on the PCB enabling fast transient response to musical demands.
Features
Comments to this Manuals